0 produs(e) - 0,00 Lei
Nu ai nici un produs in cos!

Moneda

SpeedBox for Brose



Cod produs: P0022
Disponibilitate: In Stoc

PROPERTIES:
Display shows: half the speed
Maximum speed: 50 km/h
Activation: SpeedBox always active
Necessary need of diagnostics during installation: NO

SpeedBox for Brose is a processor-controlled module what increases the maximum speed of your electric bike up to 50 km/h. The display shows half the speed after activation.

Activation and deactivation is performed by briefly pressing the button for lighting on the control panel. The display shows the lights icon when you press this button. This means that the SpeedBox is activated and the motor support of the electric bike works up to speed of 50 km/h. When the button is pressed again, the active lighting icon disappears. This means that the SpeedBox is deactivated, and everything works as it would if it weren't installed.

If the lights on a bike are not activated, they must be activated by using of diagnostic equipment. This can be done at any high-quality electric bike workshop.

Please note that the operation of such modified electric bikes on roads may be in conflict with the applicable legislation in some countries. The manufacturer takes no responsibility for damages resulting from the use of  SpeedBox or SpeedBox2 products. It is not allowed to use electric bikes equipped with SpeedBox or SpeedBox2 products on roads, bike paths and in public spaces. Electric bikes equipped with SpeedBox or SpeedBox2 products can be used exclusively on one's own property and entirely on one's own responsibility. Using SpeedBox1 and/or SpeedBox2 may be lost warranty of your ebike.

Installation of SpeedBox1 for Brose:
1. Turn your electric bike off.
2. Disconnect and remove the battery from the electric bike.
3. Remove all essential parts to get access to the motor.
4. Cut the cables from the engine to the speed sensor and strip them.
5. Connect the cables to the appropriate SpeedBox connectors according to the colours indicated.
6. Assemble the engine back to its original state.
7. Connect the battery back into your electric bike.
8. Turn your electric bike on.

Notice:

When using an electric bicycle, there are many additional hazards that do not occur during normal cycling. When using SpeedBox or SpeedBox2 products, the electric bicycle also does not meet the requirements of EN 15194 + A1, when the power of the auxiliary electric drive is not reduced or interrupted when reaching 
a speed of 25 km/h or more. Before installing and before any use of the SpeedBox or SpeedBox2 products, make sure that their use is not in conflict with the laws of the country in which you intend to use your electric bicycle. 
In the EU Member States, an electric bicycle with a SpeedBox or SpeedBox2 installed is considered a small motorcycle, which may entail the obligation to use a helmet, take out damage liability insurance (or other similar insurance), 
the registration of such a vehicle (including the location of the registration mark), including the necessity to hold the appropriate driving license, when the electric bicycle is operated on the road.
The producer assumes no responsibility for damages caused by using the SpeedBox and SpeedBox2 products.
Electric bike equipped by products SpeedBox or SpeedBox2 not allowed to use on roads, bike paths and public spaces.
An electric bike equipped by SpeedBox or SpeedBox2 products can be used solely on your own property and entirely at your own risk.

 

Spune-ti opinia

Nota: Codul HTML este citit ca si text!
Rau           Bun

NOTA: Fotografiile produselor nu creeaza obligatii contractuale fiind doar cu titlu informativ!

NOTA: Pentru comenzile ce depasesc 250 Ron transportul este gratuit!

NOTA: Bicicletele cu valoare mai mare de 999 Ron se livreaza montate si reglate!



 

GoodRide